Page 5
Installation
Before starting the installation, please read this entire section
first. Finger tighten the screws that mount the instrument
bracket - It is not necessary or recommended to use tools.
l Drill a 2-1/8" (55mm) mounting hole where you desire to
mount the instrument (Figure 1).
l Connect the various wires from Cable 1 and Cable 2 as
shown in Figures 2 and Figure 3.
l Carefully check all your wiring against figures 2 and 3 and
then mount the instrument in the hole. Use only finger tension
to tighten the bracket hold-down nuts
Figure 1
To Next Page
Loading...