- 75 -
It is to adjust the range of the off course.
(☞ the default setting is 0.25nm.)
5.2. Anchor
5.2.1. Anchor Alarm:
It is necessary when your vessel anchors.
(☞ the default setting is OFF.)
5.2.2. Anchor Radius:
If you vessel is out of the range of the anchor, it gives you notice with alarm.
(☞ the default setting is 0.05nm.)
5.3. Interval
5.3.1. Interval Alarm:
It alarms every time you set.
(☞ the default setting is OFF.)
5.3.2. Interval Time
The time is available from one minute until sixty minutes.
(☞ the default setting is 3 min.)
5.4 User Line
5.4.1. User Line Alarm
It alarms if it breaks into the setting area.
(☞ the default setting is OFF.)
5.4.2. User Line Radius
It sets the range of the course alarm.
(☞ the default setting is 0.05nm.)
To Next Page
Loading...
