6
V - SETTING WATER LEVEL
Connect the supply to the inlet valve.
N.B. : Make connecting tightness with filter
seal.
WARNINGS:
1 - Do not overtight in any case.
2 - Do not use any sealing paste and/or
compound in any case
3 - Do not use connector handling the
internal part of the inlet valve.
SIAMP will be not responsible in case
these warnings are not respected.
Allow cistern to fill and by screwing
the grey bolt slide the float to set
water level to waterline.
Ensure movement of float is not
restricted.
VI - ASSEMBLING THE BUTTON
Screw the button down, without
pushing the central part.
1
2
3
1
To Next Page
Loading...
