Figure 7: Mounting the safety light curtain without the alignment bracket: Step 2
2. Position the explosion-proof enclosure on the two screws so that the mounting
holes are directly over the partly-tightened screws.
Figure 8: Mounting the safety light curtain without the alignment bracket: Steps 3 and 4
3. Fix the upper end of the explosion-proof enclosure to the mounting surface using
two M8 screws.
4. Tighten the two lower M8 screws.
MOUNTING
3
8017025/YIZ2/2015-02-25 | SICK
Subject to change without notice
O P E R A T I N G I N S T R U C T I O N S | C4000 Select Ex
15
To Next Page
Loading...