b
Follow the alignment instructions in the underlying operating instructions.
b
Once the sender and receiver are aligned correctly, secure the components in the
alignment brackets with a torque of 28 to 28.5 Nm.
b
Switch the power supply off and then on again.
b
Check the alignment quality display as described in the underlying operating in‐
structions to make sure that components are still correctly aligned with one anoth‐
er.
ALIGNING THE SENDER AND RECEIVER 5
8017025/YIZ2/2015-02-25 | SICK
Subject to change without notice
O P E R A T I N G I N S T R U C T I O N S | C4000 Select Ex
23
To Next Page
Loading...