Chapter 1 Operating Instructions
ICR880/890 Camera Systems
8 © SICK AG · Germany · All rights reserved · Subject to change without notice 8011325/XL85/2013-08-20
Notes on this document
1.2 Target audience
The target audience of this document is persons assigned the following tasks:
1.3 Information content
This document contains all the required information for installation, electrical installation
and operation of the ICR880/890 Camera Systems at the installation location. The factory
configuration (default setting) of the Camera Systems as a stand-alone device is optimized
to a single-side reading (from above or from the side).
Configuration of the Camera Systems for the application-specific reading conditions and
operation is carried out via the SOPAS-ET Configuration Software at a Windows
TM-
PC. The
SOPAS-ET Configuration Software contains an online help system to facilitate configuration.
Installation and electrical installation of the MSC800 controller and its configuration is de-
tailed in the MSC800 Operating Instructions (part no. 8011540). These instructions also
described use of the MSC800 as a controller for a multi-side reading.
Important This document only describes customer-specific devices (hardware or functional modified)
in the parts which mets the standard devices.
Further information on Camera Systems, Volume Measurement Systems and 1D/2D Code
Scanners is available from SICK AG, Division Identification & Measuring.
On the Internet at www.sick.com.
Tasks Target audience
Installation, electrical installation, main-
tenance, replacing system components
Qualified staff, e.g. service technicians and factory elec-
tricians
Startup and configuration Qualified staff, e.g. technicians and engineers
Operation of the conveyor system Qualified staff for startup and operation of the conveyor
system
Tab. 1-1: Target audience of the document
To Next Page
Loading...
