Sicma S.p.A.
Miglianico (CH)
page 19
FIRST CHECK
After the first 50 hours of work change oil in the gear case and check all bolts and nuts tightening.
EVERY 8 HOURS OF WORK
- Grease with AGIP GREASE MU EP2 the rotor support through the lubricating nipples A
(picture 20) of CS, SA, SD, SF and HLV-HLF tillers.
- Grease the cardan shaft spider of every model of tillers.
EVERY 50 HOURS OF WORK
- Check oil level of sump/bevel gear pair (A - picture 21).
- Check oil level of the lateral drive (A - picture 22),
- Check oil level of the rotor support on ST, SM, SP, RG, SHV-SHF-SHE and SM-F tillers (A -
picture 23).
If necessary feed with AGIP ENI BLASIA 150 80W90 oil.
- On HLV-HLF and SHV-SHF-SHE tillers, check oil of their hydraulic system (cap B – picture
24) and of their mast (cap C – picture 24)
If necessary feed with AGIP OSO 68 hydraulic oil.
- Check that all bolts and nuts are strongly tightened, especially the hoes’ ones.
EVERY 500 HOURS OF WORK
- It is necessary to change oil of the group sump/bevel gear pair, of the lateral drive and of the
rotor support (ST, SM, SP, RG, HLV-HLF, SHV-SHF-SHE, SM-F); use only AGIP ENI
BLASIA 150 80W90 oil.
For this kind of maintenance please contact the nearest SICMA authorized repair shop.
Picture 20 Picture 21
Picture 22 Picture 23 Picture 24
To Next Page
Loading...