Sicma S.p.A.
Miglianico (CH)
page 9
MAIN PARTS TERMINOLOGY
A) Frame
B) Lower three-point hitches
C) Upper three-point hitch
D) Cardan guard
E) Third point mast
F) Rotor
G) Hoes
H) Side skids
I) Transmission case
L) Cover
IDENTIFICATION PLATES
Identification plates are placed on every tiller and are structured as follows:
model of tiller (example) dimension (example)
Speed gear information
(example)
When asking for information or technical service, always
specify the machine type and width.
ALLOWED USE
SICMA tillers, as described in this instruction and maintenance booklet, have been specifically
designed to till the land.
Any other use jeopardizes the operator’s safety and the machine integrity.
IMPROPER USE
When using SICMA tillers it is particularly forbidden:
- The attachment to vehicles of unsuitable power or weight.
- To assemble the machine without securing the rebound tie rods of the three-point hitch of
the tractor’s elevator.
- To work in excessively stony grounds
- To lift the machine when the power takeoff is engaged.
- To approach the machine when wearing inappropriate work clothing.
- To get on the machine while it is being used or transported
To Next Page
Loading...
