2
Specifications:
This information is also included in a label located on the side panel of the unit.
Sidewinder Model M-2
• 11A, 110-120 V, 1Ph, 60 Hz
• Condensing Unit max. fuse 15 amp at F-1
• For supply connections, use 14 AWG or larger wires suitable for at least 90°C or equivalent.
• See PLACEMENT LOCATION AND INSTALLATION for clearances, do not install closer than 16
inches to a vertical surface.
• Minimum recommended ambient temperature - 50°F (10°C)
• Maximum recommended ambient temperature - 95°F (35°C)
• Capacity 5 US Gallons
• FOR USE ON LEVEL SURFACES ONLY
********************************************************************
CAUTION
To reduce the risk of fire or explosion, install, operate and maintain this equipment in accordance
with the instruction manual. This unit is for use in 35°C (95°F) environment with no forced
ventilation. Under these conditions, the unit shall be spaced a minimum 5 ft. from potential sources
of ignition such as electrical receptacles, switches, pilot lights, fixtures, contacts, and other similar
equipment that can produce sparks. If the equipment is used in higher ambient temperatures, an
increase in spacing to sources of ignition shall be considered. This unit has only been investigated
for use with the solvents indicated in the instruction manual.
CAUTION
Whenever combustible or flammable solvent are present there is a potential for mishap.
Personnel should be trained in the safe and proper handling, use and storage of hazardous
solvents.
Your Sidewinder Solvent Distillation Unit is a safe and reliable hazardous waste management
tool when used as intended and operating personnel are trained in its proper use.
All operating personnel should familiarize themselves with this manual. Keep this manual
readily available to the user.
DANGER! -WARNING!-
DO NOT PROCESS COMPOUNDS OF NITROCELLULOSE,
CELLULOSE NITRATE , ACIDS
OR ANY UNSTABLE REACTIVES
To Next Page
Loading...