Sieg C3 - Electrical Component Disconnection

© Arc Euro Trade Ltd, England 2012
- 6 -
© A
c Eu
T
ro T
L
,
En
g
20
d 20
12
© Ar
Ar
c Eu
c Eu
ro T
ro T
rade
rade
Ltd
Ltd
, En
, En
glan
glan
d 20
d 20
12
-
6
-
39. Remove the motor cover. 40. Slacken the two drive belt adjusting screws.
41. Slacken the motor mount pivot screws and remove the drive belt. 42. Undo the motor mount pivot screws enough to remove the motor.
35. Disconnect K3 and K4 safety cut-out wires from the control board. 36. Disconnect the motor wires.
37. Disconnect the mains supply leads from the emergency stop switch. 38. Put the control box to one side.
33. Undo two screws and remove the speed display pickup. 34. Disconnect the three earth wires.