Transport, storage and packing
8 9229 9862 176 0D
2013-08-28
Transporting without pallet • Remove all tensioning belts and bits of fastening wood.
• Remove accessory pack, if applicable.
• Screw suitable eyebolts into the outer pole heads parallel to each other.
• Hang sling gear into the eyebolts.
• Carefully lift vacuum circuit-breaker off the pallet just enough that pieces of
square timber can be placed underneath.
Note
When fastening the eyebolts to the pole heads, ensure that the contact surfaces
are not damaged.
Fig. 6 Removing the tensioning belts Fig. 7 Screwing in eyebolts and lifting the vacuum
circuit-breaker
Note
Place pieces of square timber onto the pallet in such a way that the insulating
operating rods, contact pressure springs, angle levers and dashpots are not dam-
aged when setting down.
To Next Page
Loading...
