Siemens 7 - Settings for Applications; Dial-Up Network Settings; Fax Settings

Multiplexer Driver Developer’s Guide
5 Settings for Applications
s
Mux_Drv_DevGuide_v07 Page 25 of 36 2006-9-27
Confidential / Released
5 Settings for Applications
5.1 Dial-up Network Settings
The dial-up network settings must be configured according to the requirements of the network provider. The
WinMux2k driver has no special requirements.
5.2 Fax Settings
There are no special settings for the fax service of the operating systems.
Note: If the fax service is enabled for receiving fax messages, the virtual port is opened all the time. In this case
the driver cannot be disabled or unloaded. To change port settings the PC must be rebooted.