SITRANS P300 (7MF8.23.. 7MF8.24.. 7MF8.25..)
A5E03434759-01, 08/2011
17
– Turn the shield over the insulation. See Fig.
– Firmly press in the plastic seal. The O-ring will in turn press the shield against the enclosure.
5. Screw on the cable gland cover with a 23 mm open end wrench until strain relief is ensured.
6. Strip the wires.
7. Connect the wires to the terminals ① "+" and "-".
Ensure correct polarity! If necessary, ground the device using the
8. "-" connection by connecting the "-" connection to the ground terminal
②.
ದ
① Connecting terminals ⑤ Auxiliary power U
H
② Ground terminal with plastic cable gland ⑥ Load
③ Guide channel ⑦ Cable gland
④ Ground terminal for cable gland with metal cable
gland
Figure 2 Electrical connection, power supply
To Next Page
Loading...
