4
VAR Language: en; VAR issue date: 050307
Template 102x140 querleft page (4) of A31Finch en, A31008-H2920-A1-2-7619 (29.12.2005, 11:27)
© Siemens AG 2005, S_Finch_Main.fm
Codes
PIN control
You can stop the PIN prompt being
activated when the phone is switched
on, but you then risk unauthorised use
of the phone.
Press
§Change§. Enter PIN and confirm
with
§OK§.
Change PIN
You can change the PIN to any 4- to
8-digit number you find easier to
remember.
Change PIN2
(Display only if PIN2 is available).
Proceed as with Change PIN.
Change phonecode
You define the phone code (4-8 digits)
when you call up a protected function
for the first time. It is then valid for all
phone-code protected functions.
Clear SIM card barring
If the PIN is entered incorrectly three
times, the SIM card is barred. Enter the
PUK (MASTER PIN), provided by your
service provider with the SIM card, ac-
cording to instructions. If the PUK
(MASTER PIN) has been lost, please
contact your service provider.
Calling
Dialling with number keys
The phone must be switched on
(standby mode). Dial number (always
with area code, if necessary with inter-
national dialling code). To dial interna-
tional dialling code press and hold
0
until a "+" is displayed. Press
§Country§
and select country.
Short press
§Clear§ to clear the last digit,
a long press clears the entire phone
number. To dial press the Call key
A.
Accept call
The phone must be switched on
(standby mode). An incoming call will
interrupt any other use of the phone.
Press
§Answer§ or A.
Please make sure you have accepted the
call before holding the phone to your ear.
This will avoid damage to your hearing
from loud ring tones!
Handsfree
Activate: Press §Handsfr.§ and switch on
with
§Yes§
. Adjust the volume with E.
Pressing
§Handsfr.§ switches off "hands-
free talking".
Always switch off "handsfree talking" be-
fore holding the phone to your ear! This
will avoid damage to your hearing!
Direct call
If this is active, only one number
can be dialled.
§Menu§ ¢ m ¢ Security ¢ Direct call
Press
D and enter phone code. The
phone code (4- to 8-digits) is set by
you and entered at the first security
setting. Please note this code down! Con-
firm code input with
§OK§.
To dial, press and hold the right
softkey.
To switch direct call off, press and hold
. Enter phone code and confirm with
§OK§. Press §Change§ and Confirm Off with
§OK§.
Text entry
Text entry without T9
Press number key repeatedly until
the required letter appears. After a
brief interval the cursor will advance.
Example:
2
Press once briefly to type the
letter a, twice to type b, etc.
Press and hold to write the
number.
Ä,ä,1-9 Umlauts and numbers are
displayed after the relevant
letters.
To Next Page
Loading...
