Siemens AGM60.4A9 - Ordering Information; Burner Control LMV36; Dual Fuel Switch Unit AGM60

6/30
Smart Infrastructure CC1N7544en
21.05.2021
Ordering
LMV36
The basic unit is the actual burner control featuring all-polar
input/output terminals. No operating elements. Operation via
detached ancillary units for wire-bound communication.
See Basic Documentation
P7544
.
Article no. Type Mains voltage Parameter set Detectors
BPZ:LMV36.520A1 LMV36.520A1 AC 120 V North America QRA2 / QRA4 / QRA10 / QRB /
ION
S55402-C202-A100 LMV36.520A1UL AC 120 V US QRA2 / QRA4 / QRA10 / QRB /
ION
AGM60.4A9
Connected on the LMV36.
Used for switching the valve control or feedback signals and
actuators of both fuels.
See Basic Documentation
P7544
.
Article no.
Type
Mains volt
a
ge
BPZ:AGM60.4A9
AGM6
0.4A9
AC 120 V
The fuel selector is not a component of the AGM60 and does not constitute part of the
scope of delivery.
OCI410 interface between burner management system and
PC
Article no.: BPZ:OCI410
Facilitates viewing, processing, and recording of setting
parameters on site using the ACS410 PC software.
See Data Sheet
N7616
.
OCI412.10 Modbus interface
Article no.: BPZ:OCI412.10
Device serving as an interface between the LMV36 and a
Modbus system, such as a building automation and control
system (BACS). The Modbus interface is based on the
RS-485 standard.
See Data Sheet N7615.
ACS410 PC software
Article no.: BPZ:ACS410
PC software for parameterization and visualization to the
burner management system.
See Software Documentation J7352.
Burner control
Dual fuel switch unit
Fuel selector
Service tools