Siemens AZL5 series User Manual

 Siemens AG Building Technologies Division CC1U7550.5en 20.07.2017 1/14
7
550.5
Operating Instruction Heating engineer level AZL5...
(LMV50...)
Legend for Operating Instruction and AZL5...
Previous level
Cursor 
Cursor 
Next level
 Revision level
For language option, select:
Param&Display  Access Heating engineer (HF)  AZL  Language
Display
Normal operation

Display 1en
Press ESC, to get into
the main menu

Display 2en
Display depending on burner sequence.
Display of fault or error

Display 3en
Display 4en
For fixing the display, press
.
Extended display LMV50...
Overview positions of actuator and O2 value
Display 11en

P
C
V U
U
Press ENTER,
to switch
between this
both displays
Display 12en
Press ESC, to
get into the
main
menu

Siemens AZL5 series Specifications

General

Laser Wavelength	635 nm
Protection Class	IP54
Laser Class	2
Working Range	Up to 30 m (with detector)
Power Supply	Battery
Battery Type	AA

Summary

Heating Engineer Level

Display Information

Fault or Error Display

Illustrates lockout and diagnosis text display for fault conditions.

System Menu Navigation

Operational Statistics

Accesses operational status, fault history, and lockout history logs.

Parameter and Display Settings

Navigates parameter settings, including ratio control, gas, and curve parameters.

Menu Structure Overview

Parameters and Display Configuration

Burner Control Times

Configures startup, purge, and shutdown times for burner control.

Burner Control Configuration

Sets general configuration and input/output parameters for burner control.

Parameter Settings: Ratio, Gas, and Curves

Ratio Control and Gas Settings

Adjusts ratio control, gas settings, and special position parameters.

Curve Parameters and Load Limits

Defines curve parameters, load limits, and oil settings for optimal operation.

Advanced Parameter Settings

Home, Prepurge, and Ignition Positions

Configures home, prepurge, and ignition positions for actuators.

Postpurge Positions and Load Control

System Configuration and Adaptation

Temperature Limiter and Cold Start

Configuration, Adaptation, and AZL Settings

Communication and Actuator Settings

Physical Units and Communication Protocols

Actuator Addressing and Configuration

Module Specific Settings

VSD Module Configuration

O2 Module and Flue Gas Recirculation

System Configuration and Runtime Monitoring

System Configuration and Limits

Hours Run, Start Counter, and Fuel Meter

System Updating and Safety Checks

Parameter Backup and Software Loading

Safety Checks and Testing

Details safety checks, including loss of flame test and TÜV tests.