Siemens Climatix POL8T2.70/STD - Switching On the Touch Panel

Mounting and connecting
Switch on the Climatix touch panel
4
A6V11521026_en--_b
17 | 31
Use the RS485 port to connect to a Climatix controller.
1. Shut down the Climatix touch panel.
2. Connect an RJ45 connector (side B, without power branch) on the
communication cable in the product package to the RS485 port of the Climatix
touch panel.
3. Connect the other RJ45 connector (side A, with power branch) on the
communication cable to the service port of the controller.
For safety instructions, see Notes on communication [➙ 12].
Use the Ethernet port to connect to a Climatix controller.
1. Shut down the Climatix touch panel.
2. Connect an RJ45 connector (side B, without power branch) on the
communication cable in the product package to the LAN port of the Climatix
touch panel.
3. Connect the other RJ45 connector (side A, with power branch) on the
communication cable to the IP port of the controller.
4. Configure the network if necessary. See Configure the network [➙ 23].
4.4 Switch on the Climatix touch panel
Switch on the power supply.
RS485 Connection
IP connection