8 © Siemens plc1999 | G85139-H1731-U400-D2
Earth
connection
JP 300
Jumpers for
Analogue input type
Default = V
JP 301
V
I
JP 304
connects
AIN- to 0V
JP 305
connects
PI- to 0V
JP 303
Jumpers for
PI input type
Default = V
JP 302
V
I
Mains
connection
Note: Jumper in 'V' position = voltage input (default)
Jumper in 'I' position = current input
Control cable connector
(PL700)
OPm2 connector
(SK200)
LED
(green)
LED
(yellow)
Control Potentiometer
(R314)
Figure 3 Electrical Connection (CS A)
IMPORTANT
Ensure that the following tightening torques are used:
Access cover retaining screws 4.0Nm
Gland hole covers: 1.0Nm
Mains connector screws 1.0Nm
PL700 Screws 0.5Nm
Earth Connection 1.5Nm
Check that the supply voltage is correct for the
inverter used by referring to the rating label.
Cable Glands (Case Size A) PG16
To Next Page
Loading...
Need help?
General