31
en
Water hardness: The water hardness
setting can be adjusted on this appliance�
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run� The factory setting for the
water hardness is 4�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier� If a water softening
system is installed in the house, please
select the Softening system setting�
Dip the test strip briey in water, gently
shake off any drips, and check the result
after one minute�
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
Drink counter: This displays how many
drinks have been dispensed since the appli-
ance was rst put into operation.
Adjusting the
grinding unit
The rotary selector (3) adjusts the grind
settings from coarse to ne.
A Warning!
Adjust the grinding unit only while it is
running! Otherwise the appliance may
be damaged� Do not reach into the
grinding unit�
● While the grinding unit is running, adjust
the rotary selector (3) from ne (a: Turn
anticlockwise) to coarse (b: Turn clock-
wise) as required�
Note: The new setting will not become
apparent until after the second cup of
coffee�
Note: If the message Adjust coarseness!
appears in the display, the grind setting
for the coffee beans is too ne. Adjust the
grinding unit to a coarser setting�
Tip: For dark roast coffee beans, choose a
ner grind, for lighter beans a coarser grind.
To Next Page
Loading...
Need help?
General
