36
en
● Remove the cover (5f) of the brewing unit
and rinse the brewing unit (5a) thoroughly
under running water�
● Thoroughly clean the brewing unit sieve
under the running water�
Important: Do not clean with detergent or
other cleaning agents and do not put it in
the dishwasher�
● Wipe out the inside of the appliance
thoroughly with a damp cloth and remove
any coffee residues�
● Allow the brewing unit (5a) and the inside
of the appliance to dry�
● Replace the cover (5f) on the brewing unit
and reinsert the brewing unit (5a) fully
into the appliance�
● Press the eject lever (5d) up fully�
● Slide the red lock (5e) fully to the right
and close the door (5b)�
Tips on energy saving
● Switch off the fully automatic espresso
machine when not in use� To do this,
press the k off / i button (13)� The
appliance rinses and switches off�
● If possible, do not interrupt coffee or milk
froth dispensing� Cutting the coffee or milk
froth dispensing process short results in
higher energy consumption and in more
residual water collecting in the drip tray�
● Descale the appliance regularly to avoid
a build-up of limescale� Limescale residue
results in higher energy consumption�
Service Programmes
Tip: Refer also to the quick reference guide
in the storage compartment (5c)�
Depending on usage, the following
messages will appear on the display at
certain intervals:
Descale required!
or
Clean required!
or
Calc‘n‘Clean required!
The appliance should be cleaned or
descaled immediately using the corre-
sponding programme� You also have the
option of combining both processes with the
Calc‘n‘Clean function (see “Calc‘n‘Clean”).
If the service programme is not run as
instructed, the appliance may be damaged�
To Next Page
Loading...
Need help?
General
