Siemens EQ.500 classic TP5 Series - Dispensing Coffee Drinks with Milk Froth; Dispensing Milk Froth; Dispensing Hot Water; Dispensing Special Drinks

Basic operation en
19
Dispensing coffee drinks with
milk froth
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
1. Insert the suction pipe in the milk.
2. Place your pre-warmed cup under
the outlet system.
3. Press the symbol for a coffee drink
with milk.
a The display will show the drink and
your current settings.
→"Drink settings", Page20
4. Change the settings where neces-
sary:
‒ Use to adjust the amount.
→"Adjusting the amount",
Page20
‒ Use to adjust the coffee
strength.
→"Adjusting the coffee
strength", Page20
‒ Use the ground coffee compart-
ment.
→"Dispensing a coffee drink
made from ground coffee",
Page18
5. Press and wait until the process
is complete.
After preparing the drink, the milk
system will automatically clean it-
self with a short jet of steam.
Tip:If you want to stop the dispens-
ing process early, press . If you
want to stop the dispensing process
altogether, press ⁠.
Dispensing special drinks
Your appliance has other drinks be-
sides the ones that you can obtain
via the quick-selection buttons.
▶
Press several times.
→"Drinks overview", Page14
Dispensing milk froth
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶
Never touch the milk system when
it is hot.
▶
Allow the hot milk system to cool
down before touching it.
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
1. Insert the suction pipe in the milk,
e.g. Tetra Pak carton.
2. Place your pre-warmed cup under
the outlet system.
3. Press repeatedly until the dis-
play shows "Milk froth".
4. Change the setting if necessary:
‒ Use to adjust the amount.
→"Adjusting the amount",
Page20
5. Press ⁠.
a The milk froth will run out of the
outlet system.
6. Press to stop the dispensing
process.
Dispensing hot water
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶
Never touch the milk system when
it is hot.
▶
Allow the hot milk system to cool
down before touching it.
Note:If the milk system has not been
cleaned, small amounts of milk may
be dispensed with the water.