Siemens EQ.500 TQ507D03 - Page 66

en Cleaning and maintenance
66
5. Empty and insert the drip tray.
6. Remove and empty the milk con-
tainer.
7. Clean the milk container, milk tube
and suction pipe.
8. Fit the components and insert the
milk container.
→Fig. 19
9. If there is a water filter, remove it.
10.Press ⁠.
11.Empty the water tank and fill with
lukewarm water up to the "0.5l calc"
mark.
12.Dissolve one Siemens descaling tab-
let in the water tank and press ⁠.
13.Place a container with a capacity of
1l under the outlet system and
press ⁠.
a The descaling programme will run
for approx.20minutes.
14.If "Refill descaler." is shown on the
display, add more descaling solution
and press ⁠.
15.Rinse the water tank.
16.Press ⁠.
17.If there is a water filter, insert the wa-
ter filter.
→"Insert water filter", Page57
18.Press ⁠.
19.Fill the tank with fresh water up to
the "max" mark.
20.Press ⁠.
a The programme takes ap-
prox.1minute and rinses the appli-
ance.
21.Empty and insert the drip tray.
22.Open the ground coffee compart-
ment.
23.Place one Siemens cleaning tablet
into the ground coffee compartment.
24.Close the ground coffee compart-
ment and press ⁠.
25.Place a container with a capacity of
1l under the outlet system and
press ⁠.
a The cleaning programme takes ap-
prox. 7minutes.
26.Empty and insert the drip tray.
27.Remove and empty the milk con-
tainer.
28.Clean the milk container, milk tube
and suction pipe.
29.Fit the components and insert the
milk container.
→Fig. 19
a The program has ended and the ap-
pliance is ready for operation.