Siemens EQ.500 TQ507D03 - Appliance Cleaning and Descaling Programmes; Cleaning Programme Procedure; Combined CalcnClean Programme

Cleaning and maintenance en
65
8. Fit the components and insert the
milk container.
→Fig. 19
9. If there is a water filter, remove it.
10.Press ⁠.
11.Empty the water tank and fill with
lukewarm water up to the "0.5l calc"
mark.
12.Dissolve one Siemens descaling tab-
let in the water tank and press ⁠.
13.Place a container with a capacity of
1l under the outlet system and
press ⁠.
a The descaling programme will run
for approx.20minutes.
14.If "Refill descaler." is shown on the
display, add more descaling solution
and press ⁠.
15.Rinse the water tank.
16.Press ⁠.
17.If there is a water filter, insert the wa-
ter filter.
→"Insert water filter", Page57
18.Press ⁠.
19.Fill the tank with fresh water up to
the "max" mark.
20.Press ⁠.
a The descaling programme takes ap-
prox.1minute and rinses the appli-
ance.
21.Empty and insert the drip tray.
22.Remove and empty the milk con-
tainer.
23.Clean the milk container, milk tube
and suction pipe.
24.Fit the components and insert the
milk container.
→Fig. 19
a The program has ended and the ap-
pliance is ready for operation.
Using the cleaning programme
Run the cleaning programme when
your appliance prompts you. The pro-
cess takes approx.9minutes.
Requirement:The brewing unit is
cleaned.
→"Cleaning brewing unit", Page62
1. Press ⁠.
2. Use and to select "Cleaning
and care" and press ⁠.
3. Use and to select "Clean"
and press ⁠.
4. To start the programme, press ⁠.
a The display will guide you through
theprogramme.
5. Empty and insert the drip tray.
6. Open the ground coffee compart-
ment.
7. Place one Siemens cleaning tablet
into the ground coffee compartment.
8. Close the ground coffee compart-
ment and press ⁠.
9. Place a container with a capacity of
1l under the outlet system and
press ⁠.
a The cleaning programme takes ap-
prox. 7minutes.
10.Empty and insert the drip tray.
a The program has ended and the ap-
pliance is ready for operation.
Using calc'nClean
You can combine the cleaning and de-
scaling programmes using the
calc'nClean service programme. Run
the calc'nClean programme when your
appliance prompts you. The process
takes approx.43minutes.
Requirement:The brewing unit is
cleaned.
→"Cleaning brewing unit", Page62
1. Press ⁠.
2. Use and to select "Cleaning
and care" and press ⁠.
3. Use and to select
"calc'nClean" and press ⁠.
4. To start the programme, press ⁠.
a The display will guide you through
theprogramme.