Siemens EQ.6 PLUS S300 TE65 Series - Menu Settings: Automatic Shut-down; Menu Settings: Coffee Temperature; Menu Settings: Water Filter

 15
en
Menu
F
Itisimportanttosetthewaterhard-
nesscorrectly,sothattheappliance
indicatesaccuratelywhenthe
descalingprogrammeshouldberun.
Youcancheckthewaterhardnessusing
theenclosedteststriporbyaskingyour
localwatersupplier.Ifawatersoftening
systemisinstalledinthehouse,please
selecttheSoftening systemsetting.
■ Brieydiptheteststripinthewaterand
checktheresultafteroneminute.
Level Waterhardness
German(°dH) French(°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
Automatic shut-down
Settinghowlongtheapplianceshouldwait
afterthelastdrinkwaspreparedbeforeit
automaticallyswitchesitselfo󰀨.
Youcanspecifyvaluesfrom15minutesto
8hours.Thefactorysettingis30minutes.
■ Use Itochoosethedesiredinterval
andtouchBtoconfirmyourchoice.
Coffee temperature
Specifyingthetemperatureforco󰀨eedrinks
andhotwater.
You can choose normal,high,ormax.
Thesettingappliestoalltypesofdrink
preparation.
■ Use Itochoosethedesiredtemper-
aturelevelandtouchBtoconfirm
yourchoice.
Water filter
Specifyingwhetherawaterltershouldbe
activatedorwhethernolterisused.
You can choose Activate new filter or No
filter.
F
Usingawaterfiltercanpreventthe
build-upoflimescale.
Waterltersareavailablefromretailoutlets
orfromcustomerservices(seethesection
“Accessories”).
F
Important:Beforeyoucanusea
newwaterfilteritwillneedtobe
rinsed.
■ Usethemeasuringspoon8topressthe
waterlterrmlyintothewatertank5.
■ Fillthewatertankwithwateruptothe
“max”mark.
■ Connectthemilktube4ctothemilk
system4b andthesuctionpipe4d.
■ Inserttheendofthesuctionpipe4dinto
thedripplate17b.
■ Touch A and use Itoselect
Water filter.
■ Touch B and use Itoselect
Activate new filter.
■ Emptythedriptrayandre-insert.
■ Touch Btoconrm.
Waterwillnowowthroughthelterto
rinseit.
■ Thenemptythedriptrayandre-insert.
Theapplianceisreadyforuseagain.
Rinsingthefiltersimultaneouslyactivates
thesettingfordisplayingthemessage
“Please change water filter”.
Whenthismessageappears,oratthe
latestaftertwomonths,thelterwillno
longerbee󰀨ective.Itneedstobereplaced
forreasonsofhygieneandtopreventa
build-upoflimescale(whichcoulddamage
theappliance).
Ifyoudonotintendtoinsertanewlter,
selectthesettingNo filterandtouchB
toconrm.
Downloaded from www.vandenborre.be