EasyManua.ls Logo

Siemens EQ.6 PLUS S300 TE65 Series - Troubleshooting Guide

Siemens EQ.6 PLUS S300 TE65 Series
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
en Simpletroubleshooting
Problem Cause Solution
Theco󰀨eetastes“burnt”. Thebrewingtemperatureis
toohigh
Reducethetemperature,
seethesection
“Menu–Coffee temperature”.
Thegrindingsettingis
tooneorthepre-ground
co󰀨eeistoone.
Adjustthegrindingunittoa
coarsersettingorusecoarser
pre-groundco󰀨ee.
Unsuitabletypeofco󰀨ee. Changethetypeofco󰀨ee.
Thewaterlterdoesnot
stayinpositioninthe
watertank.
Thewaterlterisnot
mountedcorrectly.
Firmlypressthewaterlter
straightdownintothetank
connection.
Theco󰀨eegroundsare
notcompactandaretoo
wet.
Thegrindingsettingistoo
neortoocoarse,ornot
enoughgroundco󰀨eehas
beenused.
Adjustthegrindingunittoa
coarserornersetting,oruse
2levelmeasuringspoonsof
groundco󰀨ee.
Waterdrippedontothe
innerooroftheappli-
ancewhenthedriptray
wasremoved.
Driptraywasremovedtoo
soon.
Waitafewsecondsafterthe
lastdrinkwasdispensedbefore
removingthedriptray.
Displayshows
Please refill bean container
althoughthecontaineris
alreadyfull,orthegrinder
isnotgrindinganybeans.
Beansarenotfallinginto
thegrindingunit(beanstoo
oily).
Gentlytapthebeancontainer.
Possiblychangethetypeof
co󰀨eeused.Whenthebean
containerisempty,wipeitwitha
drycloth.
Displayshows
Please empty drip tray
despitethedriptraybeing
empty.
Emptyingisnotdetected
whentheapplianceis
switchedo󰀨.
Whentheapplianceisswitched
on,removeandre-insertthe
driptray.
Thedriptrayissoiled. Cleanthedriptraythoroughly.
Displayshows
Refill with still water or
change filter
Watertankwrongly
inserted.
Insertwatertankcorrectly.
Carbonatedwaterinthe
watertank.
Fillthewatertankwithfreshtap
water.
Floatisstuckinthewater
tank.
Removethetankandclean
thoroughly.
Newwaterlterdidnot
rinseaccordingtothe
instructions.
Rinsethewaterlteraccording
toinstructionsandthenswitch
on.
Airinthewaterlter. Dipthewaterlterintowater
untilnomoreairbubbles
escape,replacethelter.
Waterlterisold. Insertanewwaterlter.
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.
Downloaded from www.vandenborre.be

Table of Contents

Related product manuals