en operation
52
8.8 Dispensing milk froth
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶ Never touch the milk system when
it is hot.
▶ Allow the hot milk system to cool
down before touching it.
Requirements
¡ The milk tube is connected.
¡ The suction pipe is connected.
1. Insert the suction pipe in the milk,
e.g. Tetra Pak carton.
2. Place your pre-warmed cup under
the outlet system.
3. Press repeatedly until the dis-
play shows "Milk froth".
4. Change the setting if necessary:
‒ To adjust the per-cup quantity,
press .
→"Adjusting the amount",
Page53
5. Press .
a The milk froth will run out of the
outlet system.
6. Press to stop the dispensing
process.
8.9 Dispensing hot water
WARNING
Risk of burns!
The milk system can become ex-
tremely hot.
▶ Never touch the milk system when
it is hot.
▶ Allow the hot milk system to cool
down before touching it.
Note:If the milk system has not been
cleaned, small amounts of milk may
be dispensed with the water.
Requirements
¡ The milk system has been
cleaned. .
¡ The milk tube has been removed.
1. Place your pre-warmed cup under
the outlet system.
2. Press repeatedly until the dis-
play shows "Hot water".
3. Change the setting if necessary:
‒ To adjust the per-cup quantity,
press .
→"Adjusting the amount",
Page53
4. Press .
If the following message appears:
"Please remove suction hose.", re-
move the milk tube and press .
a Hot water will run out of the outlet
system.
5. Press to stop the dispensing
process.
8.10 Drink settings
Prepare a drink according to your
taste.
Adjusting the coffee strength
1. Press the symbol for your desired
drink.
2. To select the strength of the cof-
fee, press .
You can select the following coffee
strengths:
– "mild"
– "regular"
– "strong"
– "very strong"
– "doubleshot"
Note:The setting "doubleshot" is
not available for every drink and
drink volume.
Tip:For a strong taste of coffee,
select a high coffee strength when
setting a large capacity.
To Next Page
Loading...
