19.04.2000 2015-EU1-eng.fm
euroset 2015, A31008-E2015-B100-2-Y719
– 9 –
English
❏
Activating/ deactivating the call duration display
Your telephone can display the approximate call duration. If the call dura-
tion display is activated, the time display starts 12 seconds after the last
digit is dialed.
You can press
4
to restart the call duration display during a call.
Operation at private PABXs
❏
Entering/deleting exchange codes
If you are using your telephone on a private PABX, you may need to store
one or more exchange codes. A dialing pause of 3 seconds is automatically
set when the exchange code is saved.
❏
Switching the dialing mode
>
"
Lift the handset,
then start the function.
or
0 = call duration display off
1 = call duration display on.
"<
Press the set key, then replace the handset.
>"
Lift the handset then start the function.
If no exchange code has been programmed, the dis-
play shows
R
.
If one or more exchange codes have been stored,
these are displayed side-by-side; the code currently
available for editing flashes.
Press
/
to switch between the displayed exchange
codes as necessary in order to edit them as follows:
"<
(a) To delete an exchange code:
Press the set key and replace the handset.
J
(b) To eenter an exchange code:
Enter a one- to three-digit exchange code.
/J
If you want to enter another exchange code:
Press the redial key and enter the next exchange
code.
"<
Press the set key, then replace the handset.
>"
Lift the handset, then start the function.
or
1 = Tone dialling.
2 = Pulse dialing without flash function.
"<
Press the set key, then replace the handset.
To Next Page
Loading...
