Siemens EX875KYW1E - Wireless Sensor Connectivity and Settings; Connecting the Wireless Cooking Sensor; Sensor Reset and Boiling Point Adjustment

en Meal assistant
18
Home-made broths 100 60-90
Instant soups 100 5-10
Desserts
Compote 100 15-25
Frozen products
Green beans 100 15-30
Cooking in a pressure cooker
Meat
Chicken 120 15-25
Veal 120 15-25
Vegetables and legumes
Vegetables 120 3-6
Chickpeas 120 25-35
Lentils 120 10-20
Beans 120 25-35
Potatoes
Potatoes 120 10-20
Sweet potatoes 120 10-20
Pasta and cereals
Rice 120 6-8
Brown rice 120 12-18
Soups
Home-made broths 120 20-30
Frying with a large amount of oil
Use the lid to heat the oil, and remove it to fry the food.
Meat
Chicken pieces 180 10-15
Meatballs 180 10-15
Fish
Fish, breaded, battered 180 10-15
Vegetables and legumes
Vegetables, breaded, battered 180 4-8
Mushrooms, breaded or
battered
180 4-8
Desserts
Jam-filled doughnuts and
doughnuts
180 5-10
Frozen products
Chips 180 4-8
16.3 Wireless cooking sensor
To use cookingSensor, you must purchase a wireless
cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop siemens-home.bsh-group.com.
Connecting the wireless cooking sensor
To connect the wireless cooking sensor to the control
panel, proceed as follows:
1.
Opening the basic settings →Page21
2.
Select the cooking sensor setting and select the
"Add new cooking sensor" option.
3.
Briefly touch the centre of the wireless cooking
sensor within 30 seconds.
‒ After a few seconds, the result of the connection
between the cooking sensor and the control
panel appears on the display.
Result
Connected
correctly
cookingSensor is available.
Not con-
nected cor-
rectly
Communication error
¡ Repeat the connection process.
If the result is still , contact
customer service.
Not con-
nected cor-
rectly
Communication error
¡ Bluetooth communication error.
Repeat the connection process.
¡ You have not touched the
centre of the wireless cooking
sensor within 30 seconds of se-
lecting the cooking zone. Re-
peat the connection process.
¡ The battery in the wireless
cooking sensor is flat. Replace
the battery, reset the wireless
cooking sensor and repeat the
connection process.
Resetting the wireless cooking sensor
1.
Press the centre of the cooking sensor for approx. 8
- 10 seconds.
a During this process, the LED display for the wireless
cooking sensor lights up three times.
a When the LED lights up for the third time, it will start
to reset the temperature sensor.
2.
Now stop pressing the centre of the wireless cook-
ing sensor.
a As soon as the LED goes out, this means that the
wireless cooking sensor has been reset.
3.
Repeat the connection process from point 2.
Setting the boiling point
The point at which water starts to boil depends on the
height of your home above sea level. If the water is
boiling too vigorously or not vigorously enough, you
can adjust the boiling point. Proceed as follows:
Select the "Set boiling point" setting in
→"Basic settings", Page21.
The default basic setting is 200–400m. If the home is
located at this height above sea level, do not set the
boiling point. Select the setting that matches your
home's height above sea level.
Note:The temperature 3/100ºC is sufficient to boil ef-
ficiently. For a more intensive boil, select a lower level.