EasyManua.ls Logo

Siemens EX875KYW1E - Wireless Sensor Components and Maintenance; Scope of Delivery and Parts; Attaching Sensor and Silicone Patch; Battery Replacement Procedure

Siemens EX875KYW1E
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Wireless cooking sensor en
19
Wireless cooking sensor
17  Wireless cooking sensor
To use cookingSensor, you must purchase a wireless
cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop siemens-home.bsh-group.com.
17.1 Scope of delivery
After unpacking all of the parts, check for any transport
damage and for completeness of delivery.
¡ Wireless cooking sensor
¡ Silicone patch
¡ Template
17.2 Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. For fitting on the cookware:
1.
The adhesive area on the cookware must be free
from grease. Clean and dry the container thor-
oughly, and rub the adhesive area using alcohol, for
example.
2.
Remove the protective film from the silicone patch.
Adhere the silicone patch to the outside of the cook-
ware in the correct place using the enclosed tem-
plate as a guide.
3.
Press down all over the surface of the silicone
patch, including in the centre.
4.
Leave the adhesive to dry for one hour. Do not use
or rinse out the cookware during this time.
Note:If the silicone patch comes loose, use a new
one. If required, you can purchase a set with five silic-
one patches from specialist retailers, from our cus-
tomer service or on our official website siemens-
home.bsh-group.com by quoting the article number
17007119.
All adhesives break down over time when they are
stored. To prevent this from happening, place the silic-
one bases on their containers as soon as they are
cleaned.
17.3 Attaching the wireless cooking sensor
1.
Ensure that the silicone patch is completely dry be-
fore attaching the cooking sensor.
2.
Attach the cooking onto the silicone patch so that it
fits perfectly.
17.4 Replacing the battery
If the LED on the wireless cooking sensor does not
light up when pressed, the battery is discharged. Chan-
ging the battery:
1.
Remove the silicone cover from the lower section of
the cooking sensor casing and remove both screws
using a screwdriver.

Related product manuals