Siemens EX875KYW1E - Cooking Zones and Indicators; Initial Setup and Basic Operation; First-Time Use and Initial Setup; Basic Hob Operation

Before using for the first time en
9
5.3 Distribution of the cooking zones
The specified power has been measured with the
standard pots, which are described in IEC/EN
60335-2-6. The power may vary depending on the size
of the cookware or cookware material.
A A
Area Highest power level
⁠ ⁠ Power level 9
powerBoost
2200W
3700W
⁠ Power level 9
powerBoost
3300W
3700W
Area Highest power level
⁠ Power level 9
powerBoost
2600W
3700W
⁠ Power level 9
powerBoost
3300W
3700W
5.4 Cooking zone
Before you start cooking, check whether the size of the
cookware fits the cooking zone that you want to use for
cooking:
Area Cooking zone type
⁠ Single-circuit cooking zone
⁠ Flex Zone
→"flexInduction", Page11
⁠/ ⁠ Extended FlexZone
→"flexInduction Plus", Page12
5.5 Residual heat indicator
When the cooking zones are switched off, the zone in-
dicators light up red whilst the cooking zones are still
hot.
Do not touch the cooking zone while the residual heat
indicator is lit, or immediately after it goes out.
Before using for the first time
6 Before using for the first time
Observe the following recommendations.
6.1 Initial start-up
When you switch on the appliance for the first time, the
standard language setting appears on the display as a
first step to configure the hob.
You can change these settings at any time in the basic
settings. →Page21
6.2 Setting Home Connect
To start the connection settings, select the Home Con-
nect setting in the basic settings and follow the instruc-
tions in the section entitled
→"HomeConnect ", Page22.
6.3 Cooking with induction
In comparison to conventional hobs, induction techno-
logy brings with it a series of changes and has a num-
ber of benefits such as time savings when cooking and
frying, energy savings as well as greater ease of clean-
ing and care. It also offers improved heat control as the
heat is generated directly in the cookware.
Basic operation
7 Basic operation
7.1 Switching the hob on
▶
Touch ⁠.
A signal tone sounds and the touch display lights
up.
a The hob is ready to use.
reStart
▶
If you switch the appliance on within 10minutes of
switching it off, the hob operates with the settings
that were previously set. You can activate this func-
tion in the basic settings. →Page21
7.2 Switching the hob off
▶
Touch until the displays go out.
a All cooking zones are switched off.
Note:If all of the cooking zones are switched off for
longer than 30seconds, the hob is automatically
switched off.
7.3 Setting the power level in the cooking
zones
The cooking zone has 17 power levels, which are dis-
played from to with intermediate values. Select the
best power level for the food and the planned cooking
process.