Replacing bulbs
ã=Risk of burns, risk of electric shock!
from defective bulbs. Switch off fuse or pull out mains plug.
Always replace defective bulbs immediately (leave bulbs
to cool down first) to prevent the remaining bulbs from
overloading.
Important! Use only bulb of the same type and same power
(see bulb holder or rating plate inside the appliance) –
to do this remove metal-mesh grease filter.
Replacing halogen bulbs
Note: When inserting halogen bulbs, do not touch the glass
tube. Use a clean cloth to insert the halogen bulbs.
1. Carefully remove bulb ring using a suitable tool.
2. Pull out bulb and replace with bulb of the same type.
3. Insert bulb cover.
4. Insert mains plug or switch on fuse again.
LED lights
Defective LED lights may be replaced by the manufacturer, his
customer service or a qualified technician (electrician) only.
ã=Risk of injury!
due to LED lights of risk group 1. Do not look directly into the
switched on LED lights for longer than 100 seconds.
To Next Page
Loading...
Need help?
General
