GAS-Guard 8 and GAS-Guard 3 Operations and Maintenance Guide 810-1734-00 Rev A
16 of 18
Customer Replaceable Units (CRU’s)
Customer Replaceable Units (CRU’s) are defined as customer replaceable parts onsite without
decommissioning the GAS-Guard.
Part # Description
270-0004-XX Helium Dryer
290-0020-XX Regulator, CAL,
290-0017-XX Cylinder, Verification
292-0018-XX Regulator Helium
292-0019-XX Regulator Helium w/ Pressure Switch
370-0025-XX LED, Front Panel, Green
370-0026-XX LED, Front Panel, Red
370-0027-XX LED, Front Panel, Blue
430-0032-XX Fuse, TD, 4 Amps, 1/4" x 1 1/4"
750-0076-XX
Column Assembly, GAS-Guard 8
750-0084-XX Assy, Power Supply
750-0090-XX
Column Assembly, GAS-Guard 3
250-0130-XX Filter, Oil
R750-0076-XX
Replacement Column Assembly
1
, GAS-Guard 8
R750-0084-XX Refurbished Power Supply Assy
Table 6: Customer Replaceable Units
Please contact Technical Support (support@serveron.com
) for removal and installation procedures.
Cleaning
Internal Cleaning
No internal cleaning of the GAS-Guard is required; doing so may cause damage the internal
components and void the warranty.
External Cleaning
No external cleaning of the GAS-Guard is required. If external cleaning is desired, water is the only
recommended cleaning solution. Direct spray of high-pressure water onto the GAS-Guard door seal,
LED’s, oil/helium bulkhead fittings and cable glands should be avoided.
1
GAS-Guard 3 does not require replacement column assembly
To Next Page
Loading...
