g
gase
eng-
ra
-
-
-
-
_en.
m
.
.
16
GB
If your telephone is not working perfectly
No signal tone: The tone volume might be set to 0.
Lift handset, no dialling tone: Is the connecting lead
correctly plugged into the telephone and the telephone
socket?
Dialling tone audible but telephone will not dial:
The connection is OK. Is the dialling mode set correctly
(see page 7)?
PABX only: No connection or incorrect connection
when dialling from memory (e.g. redial, speed dial):
Program external line prefix.
The other party cannot hear you: Have you pressed the
Mute key? Press the key again. Is the plug from the handset
cord inserted correctly?
Recall key does not work: Set appropriate flash time.
The caller's phone number and the calls list are not
displayed:
Is the network device connected (see page 2)? Can Calling
Line Identification be used (see page 8)?
Insert strips
Blank insert strips for the repertory keys can be found on
the Internet at www.gigaset.com/cordedphones
.
Contacts
If you should encounter any problems when operating the
telephone connected to a communication system with
analogue network access, please contact the network
operator responsible or your dealer.
Authorisation
This device is intended for connection to analogue net-
works outside the EEA (with the exception of Switzer-
land) depending on national type approval.
Country-specific requirements have been taken into
consideration.
We, Gigaset Communications GmbH, declare that this
device meets the essential requirements and other rele-
vant regulations laid down in Directive 1999/5/CE.
A copy of the 1999/5/EC Declaration of Conformity is
available at this Internet address:
www.gigaset.com/docs
To Next Page
Loading...
