8
First steps
Gigaset C470/C475 / Grossbritannien / A31008-M1902-L101-1-7619 / starting.fm / 6.8.07
Version 4, 16.09.2005
Connecting the base station
¤ First connect the power supply unit
and then the phone jack as shown
below and place the cables in the cable
recesses.
1 Mains adapter 230 V
2 Phone jack with phone cord
Please note:
u The mains adapter must always be
connected, as the phone will not
operate without mains connection.
u Only use the mains adapter and phone
cord supplied.
u If you buy a replacement phone cord,
make sure that the phone jack has the
correct type of wiring.
Setting up the handset for use
The display is protected by
a plastic film. Please
remove the protective
film!
Inserting the batteries
¤ Insert the batteries the right way
round.
The polarity is indicated in/on the battery
compartment.
Closing the battery cover
¤ First insert the battery cover at the top.
¤ Then press the cover until it clicks into
place.
Correct phone jack assignment
1unused
2unused
3a
4b
5unused
6unused
2
1
1
Gigaset C470
2
1
1
Gigaset C475
3
2
1
4
5
6
Warning:
Use only the rechargeable batteries recom-
mended by Siemens (page 56). Never use a
conventional (non-rechargeable) battery or
other battery types as this could result in sig-
nificant health risks and personal injury. For
example, the batteries could explode. The
phone could also malfunction or be damaged
as a result of using batteries that are not of the
recommended type.
To Next Page
Loading...
