Siemens GIGASET C88 - Transferring a Call; Consultation Calls; Ending the Consultation Call

27
Press Keys:
Handset Operation
Manual Registration
You may also manually register additional handsets
to your base station.
åååååååååååå
MENU
Open the Menu.
ååååååå åååååååååååååååååååååååååååååååå ååååååå
Z REGISTER HS [
Scroll to Register Handsets and press OK.
PIN is displayed.
ååååååå
o [
Enter the 4-digit system PIN (default: 0000) and
press OK (see page 33 for Changing System PIN).
åååååååååååååååååååååååååååå
REGISTER HS
Entry will be flashing.
ååååååå
[
Press OK at the flashing prompt.
Underside of the base station
Hold down the Page/Registration key on the under-
side of the base station for approximately 10 sec-
onds until a signal tone is heard from the base sta-
tion.
If all internal handset numbers are assigned, the in-
tercom number 4 is reassigned. The handset that
has been registered under number 4 will be dereg-
istered.
When it has been successfully registered, the
handset reverts to the idle state.
De-registering Handsets
ååååååå
INT
Press the Intercom soft key.
ååååååå ååååååå
Z
Y
Scroll to the handset to be de-registered.
åååååååååååå
MENU
Open the Menu.
ååååååå åååååååååååååååååååååååååååååååå ååååååå
Z DE-REGISTER [
Scroll to De-register and press OK.
PIN is displayed.
ååååååå
o [
Enter the 4-digit system PIN (default: 0000) and
press OK.
åååååååååååååååååååååååååååååååå ååååååå
DE-REGISTER? [
Press OK at the prompt.