Siemens Gigaset SL55 - Page 17

16
Setting up the base station – Getting started wizard
E45-S45-SL55 ISDN-Basen / en / A31008-M368-B103-1-7619 / starting.fm / 23.03.2006
Operation on a PABX
Only carry out the following steps if you want to connect your telephone to a private
PABX (not directly to the NTBA). Depending on the PABX, it may be necessary for you to
enter an access code (outside line code) for external calls during installation; refer to the
operating instructions for your PABX for details. You can enter an access code (one to
four digits).
The display shows: Operate behind PABX?
The display shows Installation completed. Press the End call key a, to return the hand-
set to idle status.
[ RRRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
Press the display key to confirm the prompt.
[ RRRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
Press the display key to confirm the Set access
code? prompt.
~
Entering the access code (outside line code)
Í
Press the display key to open the submenu.
s
/ s Save entry
Select and confirm. The Getting started wizard is
closed.
OK