Siemens HB86K572B - Changing the Basic Settings; Automatic Switch-Off; Care and Cleaning; Cleaning Agents

16
Changing the basic settings
Prerequisite: The oven must be switched off.
Example in the picture: changing the audible signal duration
basic setting from medium to short.
1. Press and hold the ± button for roughly 4 seconds until
"Select language:" appears on the left and "English" appears
on the right.
2. Select the basic setting using the rotary selector.
3. Switch to the right-hand settings area using the ¿ button and
change the value using the rotary selector.
4. You can now make further changes to the basic settings by
switching to the basic setting using the
¾ button and making
the adjustments as described under points 2 and 3.
5. Press and hold the ± button until the display disappears. This
takes about four seconds. All changes are saved.
Cancelling
Press the
‡ button. The changes are not applied.
Automatic switch-off
Your oven has an automatic switch-off function. It is activated if
no cooking time is set and the settings have not been changed
for a long time. The point at which this occurs depends on the
temperature or grill setting that has been set.
Switch-off activated
“Automatic switch-off" appears in the display. Operation is
interrupted. Press any button to clear the text. You can make
new settings.
Note: If a cooking time is set, the oven stops heating once the
cooking time has elapsed. The automatic switch-off function is
not necessary.
Care and cleaning
With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
ã=Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
ã=Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
Notes
■ Slight differences in colour on the front of the appliance are
caused by the use of different materials, such as glass,
plastic and metal.
■ Shadows on the door panel which look like streaks, are
caused by reflections made by the oven light.
■ Enamel is baked on at very high temperatures. This can
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
■ Unpleasant odours, e.g. after fish has been prepared, can be
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
■ sharp or abrasive cleaning agents,
■ metal or glass scrapers to clean the glass in the appliance
door,
■ metal or glass scrapers to clean the door seal,
■ hard scouring pads and sponges,
■ cleaning agents with high concentrations of alcohol.
Wash new sponge cloths thoroughly before use.
Supply voltage:
220-230 V
220-230V
230-240V
Adjusting the operating voltage
Restore factory settings:
no
no
yes
Reverse all changes and restore basic
settings.
Basic setting Options Explanation
 
6HOHFWODQJXDJH
(QJOLVK

%DVLFVHWWLQJ
 
6LJQDOGXUDWLRQ
PHGLXP

%DVLFVHWWLQJ
 
6LJQDOGXUDWLRQ
VKRUW

%DVLFVHWWLQJ