10
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
■ sharp or abrasive cleaning agents,
■ metal or glass scrapers to clean the glass in the appliance
door,
■ metal or glass scrapers to clean the door seal,
■ any coarse scouring pads or cleaning sponges,
■ cleaning agents with high concentrations of alcohol.
Wash new sponge cloths thoroughly before use.
Malfunction table
Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
: Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Malfunction table
Area Cleaning agents
Appliance front Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Do not use glass clean-
ers or metal or glass scrapers for clean-
ing.
Door panels Glass cleaner:
Clean with a dish cloth. Do not use a
glass scraper.
Door seal
Do not remove.
Hot soapy water:
Clean with a dish cloth; do not scrub. Do
not use a metal or glass scraper for
cleaning.
Accessories Hot soapy water:
Soak and then clean with a dish cloth or
a brush.
Stainless steel Hot soapy water:
Clean using a dish cloth and then dry
with a soft cloth. Remove flecks of
limescale, grease, starch and albumin
(e.g. egg white) immediately. Corrosion
can form under such residues. Special
stainless steel cleaning agents can be
obtained from the after-sales service or
from specialist retailers.
Cooking compart-
ment made of stain-
less steel
Hot soapy water or a vinegar solution:
Clean using a dish cloth and then dry
with a soft cloth.
If the oven is very dirty: use oven
cleaner, but only when cooking com-
partment is cold. It is best to use a stain-
less-steel sponge. Do not use oven
spray or other aggressive oven cleaners
or abrasive materials. Scouring pads,
rough sponges and pan cleaners are
also unsuitable. These scratch the sur-
face. Allow the interior surfaces to dry
thoroughly.
Area Cleaning agents
Problem Possible cause Remedy/information
The appliance does not work Faulty circuit breaker Look in the fuse box to make sure that the
fuse for the appliance is OK.
Plug not plugged in Plug in the plug
Power cut Check whether the kitchen light is working.
Incorrect operation Switch off the circuit breaker in the fuse box.
Reconnect the circuit breaker after approx.
10 seconds.
The appliance is not in operation. A
cooking time appears in the display.
The start button was not pressed after the set-
ting had been made.
Press the start button or switch off the appli-
ance.
The microwave does not switch on. The door was not fully closed. Check whether food remains or foreign
material is trapped in the door. Make sure
that the sealing surfaces are clean. Check
whether the door seal is twisted.
The start button was not pressed. Press the start button.
It takes longer than before for the
food to heat up.
The microwave power setting is too low. Select a higher power setting.
A larger amount than usual has been placed
in the appliance.
Double the amount = almost double the time
The food was colder than usual. Stir or turn the food during cooking
To Next Page
Loading...
Need help?
General
Weight and Dimensions
