EasyManua.ls Logo

Siemens Hicom 300E - Charging the batteries

Siemens Hicom 300E
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Putting into service
Charging the batteries
Batteries supplied are not charged.
Note:
l New batteries should be initially charged for a minimum period of 16
hours without interruption – irrespective of any messages on the
display.
l In order to maintain max. battery storage capacity for as long as
possible, the mobile unit should only ever be inserted in the charging
shell when the batteries are empty.
l The batteries warm up during charging.
l Only the following spare batteries are permitted:
Panasonic P-60 AA, Philips R6 NC-P, Saft RC6, UCAR RC6, DAIMON
ACCU 1000, Varta 751RS, Sanyo N-3UN and N-3UC.
l Insert the mobile unit in the Gigaset 2000L charging shell to charge the
batteries. The mobile unit can be inserted with the display facing
upwards or downwards.
The left LED Bon the charging shell lights up while the batteries
are charging.
Charging times:
Batteries in the mobile unit: 4 - 5 hours
Replacement batteries in the reserve compartment of the
charging shell: 20 - 24 hours
Battery life:
These times are only achieved after several charging and discharging
cycles.
between 70 and 130 hours in stand-by mode
between 7 and 13 hours when phone is in use.
U Display at 100% V Display at 66%
e Display at 33% = Display when batteries are
almost flat

Related product manuals