Siemens IQ100 KI86V Series - Operating Tips and Best Practices; Setting the Temperature; Advanced Functions; Super Function Usage Guide

Additional functions en
15
Note:If the appliance has been
previously switched off using the
control panel, press and hold
for threeseconds.
a The appliance begins to cool.
2. Set the required temperature.
→Page15
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The housing around the freezer
compartment is temporarily heated
slightly. This prevents condensa-
tion in the area of the door seal.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶
Press .
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
▶
Press repeatedly until the tem-
perature display shows the re-
quired temperature.
The recommended temperature in
the refrigerator compartment is
4°C.
→""OK" sticker", Page16
Setting the freezer compartment
temperature
▶
In order to set the freezer compart-
ment temperature, change the re-
frigerator compartment temperat-
ure →Page15.
The refrigerator compartment tem-
perature influences freezer com-
partment temperature. Refrigerator
compartment temperatures that
are set to warm generate warmer
freezer compartment temperatures.
Additional functions
8 Additional functions
Additional functions
8.1 Super function
With the Super function, the refriger-
ator compartment and the freezer
compartment cool more intensively.
Switch on the Super function 4 to
6hours before placing food weighing
2kg or more.
In order to utilise the freezing capa-
city, use the Super function.
→"Freezing capacity", Page17
Note:When the Super function is
switched on, increased noise may
occur.
Switching on Super function
▶
Press repeatedly until lights
up.
Note:After approx. 48hours, the ap-
pliance switches to normal operation.
Switching off Super function
▶
Press .