Siemens iQ500 KD86N Series - Basic Operation; Switching On the Appliance; Setting the Temperature

Basic operation en
19
Ice cube tray
Use the ice cube tray to make ice
cubes.
Making ice cubes
Use only drinking water tomake ice
cubes.
1. Fill the ice cube tray with drinking
water up to ¾ and place in the
freezer compartment.
If the ice cube tray is stuck to the
freezer compartment, loosen it with
a blunt implement only (e.g. spoon
handle).
2. To loosen the ice cubes, twist the
ice cube tray slightly or hold it
briefly under flowing water.
Basic operation
7 Basic operation
Basic operation
7.1 Switching on the appli-
ance
1. Electrically connect the appliance.
→Page16
Note:If the appliance has been
previously switched off using the
control panel, press and hold
for tenseconds.
a The appliance begins to cool.
a A warning signal sounds and the
temperature display (freezer com-
partment) and flash because
the freezer compartment is still too
warm.
2. Switch off the warning signal using
.
a goes out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page19
7.2 Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put any food in the appli-
ance until the set temperature has
been reached.
¡ The front and side panels of
thehousing heat up occasionally.
This prevents condensation from
forming.
¡ When you close the door, a va-
cuum may be created. The door is
then difficult to open again. Wait a
moment until the vacuum is offset.
7.3 Switching off the appli-
ance
▶
Press and hold for tenseconds.
7.4 Setting the temperature
Setting the refrigerator
compartment temperature
1. Select the refrigerator compart-
ment using .
2. Press / repeatedly until the
temperature display (refrigerator
compartment) shows the required
temperature.
The recommended temperature in
the refrigerator compartment is
4°C.
Setting the storage container
temperature
1. To reduce the temperature, slide
the temperature controller in the
direction.
2. To increase the temperature, slide
the temperature controller in the
direction.
→Fig.
13