Siemens iQ700 BE732 1 1I Series - 17.2 Information on display panel; Disposal; 18.1 Disposing of old appliance

en Disposal
20
17.2 Information on display panel
Fault Cause and troubleshooting
Message showing "D"
or "E" appears in the
display.
Malfunction
1.
Reset appliance.
‒ Either press and hold for at least 6 seconds.
‒ Or switch off the circuit breaker or fuse in the electrical panel. Switch the fuse back
on after approx. 10 seconds.
a If the fault was a one-off, the message will disappear.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→"Customer Service", Page21
Disposal
18 Disposal
18.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.