Siemens iQ700 GI81NH Series - Home Connect Management; Home Connect: Updates, Resetting, and Data Protection

HomeConnect en
17
10.2 Setting up HomeCon-
nect
Requirements
¡ The HomeConnectapp has been
installed on your mobile device.
¡ The appliance is receiving signals
from the WLAN home network (Wi-
Fi) at its installation location.
1. Open the HomeConnect app and
scan the following QR code.
2. Follow the instructions in the
HomeConnect app.
10.3 Installing updates for the
Home Connect software
The appliance searches for updates
to the HomeConnect software at reg-
ular intervals.
Note:If updates are available, the
temperature display shows "UP".
To reset the update and the temper-
ature display to the set temperature,
press any touch field.
1. Press .
a The temperature display shows
"Cn".
2. Press repeatedly until the tem-
perature display shows "UP".
3. Press .
a The temperature display shows an
animation.
a The update is installed.
a The control panel is locked during
the installation.
a If the installation is successful, the
temperature display shows "On".
4. If the temperature display shows
"Er", the appliance was unable to
install the update.
‒ Repeat the process at a later
point.
5. If the update cannot be completed
after several attempts, contact cus-
tomer service →Page25 .
10.4 Resetting HomeConnect
settings
If your appliance experiences con-
nection problems with the WLAN
home network (Wi-Fi) or your appli-
ance wants to log into a different
WLAN home network (Wi-Fi), you can
reset the HomeConnectsettings.
1. Press .
a The temperature display shows
"Cn".
2. Press repeatedly until the tem-
perature display shows "rE".
3. Press .
a The temperature display shows an
animation for 15seconds.
a The temperature display shows
"On".
a The HomeConnect settings have
been reset.
10.5 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your