Siemens iQ700 LC68BUV50 - Page 7

Basic operation en
7
7.6 Switching on the boost function
The boost function is a short-term maximum power set-
ting which can be activated in any fan setting.
▶
Press ⁠.
a After approx. 20 seconds, the fan automatically
switches back to the fan setting that was previously
set.
7.7 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press until appears on the display.
a The fan run-on starts at fan setting1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
7.8 Switching off the fan run-on
▶
Slide your finger to the right over the settings area
⁠.
7.9 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
▶
Press ⁠.
7.10 Switching off automatic mode
▶
Press ⁠.
a The appliance starts at the previously selected fan
setting.
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
7.11 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting:3
¡ Lowest setting:1
¡ Highest setting:5
7.12 Setting the sensor sensitivity
Requirement:The appliance is switched off.
1.
Press and hold ⁠.
a The setting is displayed after approx. onesecond.
2.
To change the setting, slide your finger over the set-
tings area ⁠.
3.
Release to save the setting.
7.13 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Note:You can set the saturation indicator in the Home
Connect app depending on the filter used.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.14 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off, ap-
pears in the display for the grease filter.
¡ After the appliance has been switched off, ap-
pears in the display for the odour filter.
▶
Slide your finger to the left over the settings area
⁠.
a The saturation indicator is reset.
7.15 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:The appliance is switched off.
1.
Press and hold and ⁠.
‒ To set circulating-air mode (non-regenerative fil-
ter), press ⁠.
‒ To set circulating-air mode (regenerative filter),
press ⁠.
‒ To set air extraction mode, press ⁠.
2.
Release and to save the setting.
7.16 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press ⁠.
7.17 Setting the brightness
▶
Press and hold until the required brightness is
reached.