Operating the appliance en
7
Fan run-on time
Switching on
Touch the x symbol.
The fan will run at fan setting 1.
After approximately 10 minutes, the fan will switch itself
off automatically.
Switching off
Touch the x symbol.
This immediately stops fan run-on.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
■ Metal grease filter: !
■ Activated charcoal filter: "
■ Metal grease filter and activated charcoal filter: !
and "
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 9
The saturation indicators can be reset while they are
flashing. To do this, touch the A symbol.
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■ The extractor hood must be connected and switched
off.
■ Touch and hold the # and @ symbols at the same
time until "2" lights up for air recirculation mode
(filters that cannot be regenerated).
■ Repeatedly touching and holding this button
combination makes "3" light up for air recirculation
mode (filters that can be regenerated).
■ Repeatedly pressing and holding this button
combination switches the electronic controller back
over to air extraction mode ("1" ).
Audible signal
Switching on
Touch and hold the # and & symbols at the same time
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is activated, ‚ will be lit.
Switching off
Touch and hold the # and & symbols at the same time
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is deactivated, ‹ will be lit.
Control panel model 2
Setting the fan
Switching on
■ Touch the # symbol.
The fan starts at setting ƒ.
■ Touch the + or - symbol to alter the fan speed.
Switching off
Touch the # symbol.
Lighting
The lighting can be switched on and off independently
of the fan.
Touch the = symbol.
Setting the brightness
Press and hold the = symbol until the desired
brightness is reached.
Symbol Explanation
#
Fan on/off
=
Light on/off/dimming
A
Reduce fan setting/fan run-on
@
Increase fan setting
&
Intensive mode
i
emotionLight Pro
Indicator/
symbol
Explanation
!
Metal grease filter saturation indicator
"
Activated charcoal filter saturation indicator
1-3 Fan settings
x
Fan run-on
2
Intensive mode
To Next Page
Loading...
