How to prevent grease filter fire in Siemens LC91KWP60 Ventilation Hood?
Fatty deposits in the grease filter of your Siemens Ventilation Hood can catch fire. To prevent this, clean the grease filter regularly and never operate the appliance without a grease filter.
What to do if hot oil or fat catches fire in my Siemens LC91KWP60 Ventilation Hood?
Hot oil and fat can ignite very quickly, posing a fire risk. Therefore, you should never leave hot fat or oil unattended and never use water to extinguish burning oil or fat. Instead, switch off the hotplate and carefully extinguish flames using a lid, fire blanket, or similar item.
What to do if my Siemens Ventilation Hood gives me an electric shock?
A defective Siemens Ventilation Hood may cause electric shock. Never switch on a defective appliance. Unplug the appliance from the mains or switch off the circuit breaker in the fuse box and contact the after-sales service.
Why is it dangerous to do incorrect repairs to my Siemens Ventilation Hood?
Incorrect repairs to your Siemens Ventilation Hood are dangerous and pose a risk of electric shock. Repairs may only be carried out and damaged power cables replaced by trained after-sales technicians. If the appliance is defective, unplug it from the mains or switch off the circuit breaker in the fuse box and contact the after-sales service.
How to prevent poisoning from flue gases with my Siemens Ventilation Hood?
When operating in exhaust air mode, ensure adequate fresh air in the room, especially if a room air-dependent heat-producing appliance is also in operation. This prevents the risk of poisoning from flue gases being drawn back in.
How to avoid corrosion damage to my Siemens LC91KWP60 Ventilation Hood?
To avoid corrosion damage to your Siemens Ventilation Hood, always switch on the appliance while cooking to prevent condensation.
How to prevent surface damage when cleaning my Siemens LC91KWP60 Ventilation Hood?
To prevent surface damage to your Siemens Ventilation Hood due to incorrect cleaning: - Clean stainless steel surfaces only in the direction of the grain. - Do not use any stainless steel cleaners for operator controls.
How to prevent damage from returning condensate in my Siemens Ventilation Hood?
To prevent damage from returning condensate in your Siemens Ventilation Hood, install the exhaust duct so that it falls away from the appliance slightly, with a 1° slope.
How long can I operate two gas burners simultaneously on my Siemens LC91KWP60 Ventilation Hood?
Never operate two gas burners simultaneously on the highest flame for longer than 15 minutes to prevent excessive heat buildup, which poses a fire risk.
What to avoid when cleaning the electronic components of my Siemens LC91KWP60 Ventilation Hood?
To avoid humidity entering the electronic circuitry of your Siemens Ventilation Hood, never clean operator controls with a wet cloth.
General| Type | Wall-mounted |
|---|---|
| Width | 90 cm |
| Noise Level | 60 dB |
| Lighting | LED |
| Control Type | Electronic |
| Energy efficiency class | A |
| Number of speeds | 3 |
| Lighting type | LED |
To Next Page