11 EN
Step 2.1: Connect your extractor hood to
your home network with WPS
Please enter step 2.1 only when prompted to by the app.
The following steps describe operations at the home
appliance itself.
Note:
To connect the extractor hood to your home
network, the hood and the light must be switched
off. You can cancel the process at any time by
pressing
.
1 | Press and hold the b symbol on your extractor hood until the
and – indicators start to ash.
2 | Press +repeatedly until
and
ash to start automatic login
to your home network.
3 | Activate the WPS function on your home network router
within the next 2minutes.
If connection to the home network is successful,
and
ash on the display panel.
The app will get notied once your extractor hood has been
successfully connected to your Wi-Fi network.
4 | Follow the instructions in the app.
Information:
If the connection could not be established within
2 minutes, make sure your extractor hood is within
the range of your Wi-Fi network.
For some appliances the WPS mode is also called
"automatic mode".
1
2
To Next Page
Loading...
