en Faults and what to do about them
24
Note: If you cannot rectify the fault yourself by turning the dryer off and on, please
contact our after-sales service.
Drying time too long? ■ The fluff filter may be dirty and cause a longer drying time. Clean the fluff
filter.
■ If the air inlet on the dryer is blocked or not freely accessible, this may
increase the drying time. Make sure that the air inlet remains unobstructed.
■ If the ambient temperature is higher than 35 °C, this may extend the drying
time.
■ Insufficient air circulation in the room may increase the drying time. Venti-
late the room.
Display panel goes off
and Start button flashes.
Not a fault. Energy-saving mode is active ~ Page 7.
Residual water in the
condensate container
despite the dryer being
connected to the con-
densation drain*.
Not a fault. If the condensation drain is installed, residual water remains in the
condensate container due to the dryer's self-cleaning function.
Humidity in the room
increases.
Not a fault. Make sure the room is sufficiently ventilated.
Power cut. The drying programme is interrupted. Remove the laundry and spread it out, or
restart the programme.
Unusual noises when
drying.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger ~ Page 21.
The dryer feels cold
despite drying.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.
Faults Cause/remedy
* Depending on the model
To Next Page
Loading...
