en Installation and connection
30
6. Pull out the condensate container
fully.
7. Turn the condensate container 180°
onto its underside and remove the
stopper that is fitted. Turn the
condensate container back and
insert the stopper into the recess on
the top side of the condensate
container.
8. Pull the filter out of the notch and
place it into the recess on the
condensate container.
9. Slide in the condensate container
until it clicks into place.
The condensation is now discharged via
the drain hose into the waste-water
system or into a wash basin.
Note: If you want to change the
condensation drain back to the
condensate container, carry out these
steps in reverse order.
To Next Page
Loading...
