en
27
Fittings
All variable parts of the appliance can be
taken out for cleaning.
Note
The partition between the cooling
compartment and the hyperFresh
compartment is permanently fixed. To
prevent any damage to the appliance,
this may only be removed by customer
service or authorized specialists.
Taking out shelves in the door
Fig. 3
Lift shelves upwards and take out.
Taking out glass shelves
Pull the glass shelves forwards and take
out.
Taking out container
Fig. 8
Pull out the container all the way and lift
to detach it from the holder.
To insert the container, place on the
telescopic rails and push into the
appliance. Attach the container by
pressing it down.
Taking out frozen food container
Fig. 9
Pull out the frozen food container all the
way, lift at the front and remove.
Lighting (LED)
Your appliance features maintenance-
free LED lighting.
This lighting may be repaired by
customer service or authorised
technicians only.
Saving energy
■ Install the appliance in a dry, well-
ventilated room. The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
■ Allow warm food and drinks to cool
down before placing them in the
appliance.
■ Thaw frozen food in the cooling
compartment and use the low
temperature of the frozen food to cool
food.
■ Open the appliance as briefly as
possible.
■ To achieve the lowest energy
consumption, leave a small amount of
distance to the wall at the side.
■ The arrangement of the fittings does
not affect the energy consumption of
the appliance.
To Next Page
Loading...
